How to wire the lighting electrical ready board on site?

Connecting lighting electrical ready boards is a task that requires professional skills and meticulous operation. The following are the steps and precautions for wiring the lighting electrical ready board on site:

1、 Preparation stage

Ensure that all necessary tools and materials are prepared, such as wires, screwdrivers, wire strippers, plastic ties, etc.

Check if the electrical ready board is securely installed and ensure that its interior is clean and free of debris.

Determine the specifications and quantity of wires based on the design drawings and actual site conditions.

2、 Wiring steps

Firstly, connect the neutral wire to the neutral wire terminal of the electrical ready board, which is usually blue in color.

Next, connect the live wire (phase wire) to the corresponding switch or circuit breaker inside the electrical ready board. Pay attention to distinguishing the three-phase lines A, B, and C, with colors of yellow, green, and red respectively.

Connect the wires to the corresponding switches or sockets according to the type of load (such as lighting equipment, sockets, etc.).

Use plastic zip ties to neatly tie the wires together to avoid confusion and looseness.

Check whether all wiring is firm and reliable, and confirm that there are no errors before conducting power on testing.

3、 Precautions

During the wiring process, it is essential to follow safety operating procedures to ensure personal and equipment safety.

Wire joints should be insulated with insulating tape or terminal blocks to prevent short circuits and electric shock accidents.

After the wiring is completed, the electrical ready board should be labeled and recorded for subsequent maintenance and repair.

In short, wiring the lighting electrical ready board requires professional skills and meticulous operation. It is essential to ensure that the wiring is correct, secure, and reliable, and to comply with safety operating procedures.